Port Status; C Ha Pte R 44 Po Rt Sta Tus; Overview - ZyXEL Communications GS1350 Series User Manual

44.1 O ve rvie w
This chapter introduces the port status screens.
44.2 Po rt Sta tus
This screen displays a port statistical summary with links to each port showing statistical details. To view
the port statistics, click
section of the
L inks
Ma na g e m e nt
Fig ure 233
The following table describes the labels in this screen.
Table 157 Port Status
L ABEL
Port
Name
Link
State
PD
in all Web Configurator screens and then the
Sta tus
screen to display the
Sta tus
> to see the following screen.
Po rt Sta tus

Port Status

DESC RIPT IO N
This identifies the Ethernet port. Click a port number to display the
Figure 234 on page 317).
This is the name you assigned to this port in the
This field displays the speed (either
the duplex ( for full duplex or
F
combo ports. This field displays
If STP (Spanning Tree Protocol) is enabled, this field displays the STP state of the port. See
13.1 on page 144 for more information.
If STP is disabled, this field displays
When LACP (Link Aggregation Control Protocol) and STP are in blocking state, it displays
.
Blo c king
This field displays whether or not a powered device (PD) is allowed to receive power from the
Switch on this port.
GS1350 Series User's Guide
C
HA PTER
Po rt Sta tus
screen as shown next. You can also click
Po rt Sta tus
Ba sic Se tting
for 10 Mbps,
10M 100M
for half). It also shows the cable type (
H
if the port is not connected to any device.
Do wn
if the link is up, otherwise, it displays
FO RWARDING
315
4 4
link in the
Po rt Sta tus
screen (refer to
Po rt De ta ils
> screen.
Po rt Se tup
for 100 Mbps, or for 1 Gbps) and
1G
or
C o ppe r Fib e r
ST O P
Q uic k
) for the
Section
.