Configure Snmp User - ZyXEL Communications GS1350 Series User Manual

Fig ure 202
The following table describes the labels in this screen.
Table 134 Management > Access Control > SNMP > Trap Group > Port
L ABEL
Option
Port
*
Active
Apply
Cancel
34.3.3 C o nfig ure SNMP Use r
From the
SNMP
for authentication with managers using SNMP v3 and associate them to SNMP groups. An SNMP user is
an SNMP manager.
Chapter 34 Access Control
Management > Access Control > SNMP > Trap Group > Port
DESC RIPT IO N
Select the trap type you want to configure here.
This field displays a port number.
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the trap type of SNMP traps on this port.
Clear this check box to disable the sending of SNMP traps on this port.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
screen, click to view the screen as shown. Use the
Use r
GS1350 Series User's Guide
Sa ve
272
link on the top navigation panel to
screen to create SNMP users
Use r