Service Access Control - ZyXEL Communications GS1350 Series User Manual

Table 136 Management > Access Control > Logins (continued)
L ABEL
Privilege
Apply
Cancel
34.5 Se rvic e Ac c e ss C o ntro l
Service Access Control allows you to decide what services you may use to access the Switch. You may
also change the default service port and configure "trusted computers" for each service in the
Ma na g e m e nt
screen.
Fig ure 205
The following table describes the fields in this screen.
Table 137 Management > Access Control > Service Access Control
L ABEL
Services
Active
Service Port
Chapter 34 Access Control
DESC RIPT IO N
Type the privilege level for this user. At the time of writing, users may have a privilege level of 0,
3, 13, or 14 representing different configuration rights as shown below.
• 0 – Display basic system information.
• 3 – Display configuration or status.
• 13 – Configure features except for login accounts, SNMP user accounts, the
authentication method sequence and authorization settings, multiple logins, administrator
and enable passwords, and configuration information display.
• 14 – Configure login accounts, SNMP user accounts, the authentication method
sequence and authorization settings, multiple logins, and administrator and enable
passwords, and display configuration information.
Users can run command lines if the session's privilege level is greater than or equal to the
command's privilege level. The session privilege initially comes from the privilege of the login
account. For example, if the user has a privilege of 5, he/she can run commands that requires
privilege level of 5 or less but not more.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
screen (discussed later). Click
Management > Access Control > Service Access Control
DESC RIPT IO N
Services you may use to access the Switch are listed here.
Select this option for the corresponding services that you want to allow to access the Switch.
For Telnet, SSH, FTP, HTTP or HTTPS services, you may change the default service port by typing
the new port number in the
will have to let people (who wish to use the service) know the new port number for that
service.
GS1350 Series User's Guide
Sa ve
to go back to the main
Ac c e ss C o ntro l
field. If you change the default port number then you
Se rvic e Po rt
276
link on the top navigation panel to
Ac c e ss C o ntro l
Re m o te