Poe Setup - ZyXEL Communications GS1350 Series User Manual

48.4 Po E Se tup
Use this screen to set the PoE power management mode, priority levels, power-up mode and the
maximum amount of power for the connected PDs.
Click >
Po rt
Fig ure 249
The following table describes the labels in this screen.
Table 169 Port > PoE Setup > PoE Setup
L ABEL
PoE Mode
Continuous
PoE
Port
*
Active
> , the following screen opens.
Po E Se tup Po E Se tup
Port > PoE Setup > PoE Setup
DESC RIPT IO N
Select the power management mode you want the Switch to use.
• – Select this if you want the Switch to reserve the maximum power for each PD
C la ssific a tio n
according to the PD's power class and priority level. If the total power supply runs out, PDs
with lower priority do not get power to function. In this mode, the maximum power is reserved
based on what you configure in
• – Select this if you want the Switch to supply the actual power that the PD
C o nsum ptio n
needs. The Switch also allocates power based on a port's
class and priority level. The Switch puts a limit on the maximum amount of power the PD can
request and use. In this mode, the default maximum power that can be delivered to the PD is
33 W (IEEE 802.3at Class 4) or 22 W (IEEE 802.3af Classes 0 to 3).
Select to guarantee continuous power supply to the connected PDs while the Switch is
O N
restarting after a warm reboot. The Switch will NOT perform a power cycle on the connected PDs.
If you do a cold reboot, the Switch also restarts the connected PDs.
This is the port index number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this to provide power to a PD connected to the port.
If left unchecked, the PD connected to the port cannot receive power from the Switch.
GS1350 Series User's Guide
Chapter 48 Port
or the standard power limit for each class.
Ma x Po we r
338
and the PD's power
Ma x Po we r