Poe Status - ZyXEL Communications GS1350 Series User Manual

Table 167 Port > Auto PD Recovery (continued)
L ABEL
Polling Count
Action
Resume Polling
Interval (sec)
PD Reboot Count
Resume Power
Interval (sec)
Apply
Cancel
48.3 Po E Sta tus
A powered device (PD) is a device such as an access point or a switch, that supports PoE (Power over
Ethernet) so that it can receive power from another device through an Ethernet port.
You can also set priorities so that the Switch is able to reserve and allocate power to certain PDs.
Note: The PoE (Power over Ethernet) devices that supply or receive power and their
connected Ethernet cables must all be completely indoors.
Chapter 48 Port
DESC RIPT IO N
Specify how many times the Switch is to resend a ping request before considering the PD
unreachable.
For example, If there is no ping reply from the PD after the
starts from 1. After
C o unt Po lling C o unt
the > screen (see
Sta tus Ne ig hb o r
perform your choice in the
Ac tio n
Set the action to take when the connected PD has stopped responding.
Select to have the Switch turn OFF the power of the connected PD (the
Re b o o t- Ala rm
connecting port is detected as link-down) and turn it back ON again to restart the PD after
sending an SNMP trap and generating a log message.
When restarting, the PD entry disappears from the Switch's LLDP table and the
status LED will turn to yellow in the
for details).
Select to have the Switch send an SNMP trap and generate a log message.
Ala rm
Specify the number of seconds the Switch waits before monitoring the PD status again after it
restarts the PD on the port.
Specify how many times the Switch attempts to restart the PD on the port.
The will reset
PD Re b o o t C o unt
• as soon as a ping is successful,
• or when any modification to the
• or after restarting the Switch.
Specify the number of seconds the Switch waits before supplying power to the connected PD
again after it restarts the PD on the port.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
save your changes to the non-volatile memory when you are done configuring.
Click this to reset the values in this screen to their last-saved values.
GS1350 Series User's Guide
335
Po lling Inte rva l
reaches 3, the
PD He a lth
Section 45.2.1 on page 324
field.
> screen (see
Sta tus Ne ig hb o r
screen is applied,
Auto PD Re c o ve ry
link on the top navigation panel to
Sa ve
has elapsed,
Po lling
status LED will turn to red in
for details). The Switch will then
PD He a lth
Section 45.2.1 on page 324