Vlan; What You Can Do; What You Need To Know - ZyXEL Communications GS1350 Series User Manual

The following table describes the labels in this screen.
Table 175 Switching > Loop Guard
L ABEL
Active
Port
*
Active
Apply
Cancel
49.7 VL AN
This section shows you how to configure 802.1Q tagged and port-based VLANs.
49.7.1 Wha t Yo u C a n Do
• Use the
VL AN Sta tus
• Use the
VL AN De ta il
the VLAN group.
• Use the
Sta tic VL AN
parameters for the Switch.
• Use the
VL AN Po rt Se tting
802.1Q) settings on a port.
49.7.2 Wha t Yo u Ne e d to Kno w
Read this section to know more about VLAN and how to configure the screens.
Chapter 49 Switching
DESC RIPT IO N
Set the switch to to enable loop guard on the Switch.
O N
The Switch generates syslog, internal log messages as well as SNMP traps when it shuts down a
port via the loop guard feature.
This field displays the port number.
Settings in this row apply to all ports.
Use this row only if you want to make some settings the same for all ports. Use this row first to set
the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the loop guard feature on this port. The Switch sends probe
packets from this port to check if the switch it is connected to is in loop state. If the switch that
this port is connected is in loop state the Switch will shut down this port.
Clear this check box to disable the loop guard feature.
Click to save your changes to the Switch's run-time memory. The Switch loses these
Apply
changes if it is turned off or loses power, so use the
your changes to the non-volatile memory when you are done configuring.
Click to begin configuring this screen afresh.
C a nc e l
screen (Section 49.8 on page
screen (Section 49.8.1 on page
screen (Section 49.9 on page
screen (Section 49.10 on page
GS1350 Series User's Guide
link on the top navigation panel to save
Sa ve
354) to view and search all VLAN groups.
355) to view detailed port settings and status of
356) to configure and view 802.1Q VLAN
358) to configure the static VLAN (IEEE
351