Configure Snmp User - ZyXEL Communications GS1915 Series User Manual

Table 134 Management > Access Control > SNMP > Trap Group > Port (continued)
LABEL
*
Active
Apply
Cancel

32.3.3 Configure SNMP User

From the SNMP screen, click User to view the screen as shown. Use the User screen to create SNMP users
for authentication with managers using SNMP v3 and associate them to SNMP groups. An SNMP user is
an SNMP manager.
Figure 190 Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Table 135 Management > Access Control > SNMP > User
LABEL
User Information
Username
Chapter 32 Access Control
DESCRIPTION
Settings in this row apply to all ports.
Use this row only if you want to make some of the settings the same for all ports. Use this row
first to set the common settings and then make adjustments on a port-by-port basis.
Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the trap type of SNMP traps on this port. The Switch sends the
related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to
save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Note: Use the user name and password of the login accounts you specify in this
screen to create accounts on the SNMP v3 manager.
Specify the user name of a login account on the Switch. The string should not contain [ ? ], [ |
], [ ' ], [ " ] or [ , ].
GS1915 Series User's Guide
263