Table of Contents
Advertisement
Table 238 Management > Access Control > SNMP > Trap Group > Port (continued)
LABEL
Port
1/*
Active
Apply
Cancel
48.3.7 Configuring SNMP User
From the SNMP screen, click User to view the screen as shown. Use the User screen to create
SNMP users for authentication with managers using SNMP v3 and associate them to SNMP groups.
An SNMP user is an SNMP manager.
Figure 354 Management > Access Control > SNMP > User
The following table describes the labels in this screen.
Table 239 Management > Access Control > SNMP > User
LABEL
User Information
Username
Chapter 48 Access Control
DESCRIPTION
This field displays a port number. In stacking mode, the first number represents the slot
and the second the port number.
Settings in this row apply to all ports for the Switch represented by the slot ID (in stacking
mode).
Use this row only if you want to make some of the settings the same for all ports. Use this
row first to set the common settings and then make adjustments on a port-by-port basis.
Note: Changes in this row are copied to all the ports as soon as you make them.
Select this check box to enable the sending of SNMP traps on this port. The Switch sends
the related traps received on this port to the SNMP manager.
Clear this check box to disable the sending of SNMP traps on this port.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top navigation
panel to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Note: Use the username and password of the login accounts you specify in this screen to
create accounts on the SNMP v3 manager.
Specify the username of a login account on the Switch.
GS3700/XGS3700 Series User's Guide
469
Advertisement
Table of Contents
