Servicing And Maintenance; Preventive Measures For Servicing And Safe Operation; Maintenance; Disposal And Recycling - AUMA SA-UW Operation Instructions Manual

SA 07.2-UW

Servicing and maintenance

11. Servicing and maintenance
AUMA
Service & Support
11.1.

Preventive measures for servicing and safe operation

11.2.

Maintenance

Lubrication
11.3.

Disposal and recycling

58
SA 16.2-UW / SAR 07.2-UW
Damage caused by inappropriate maintenance!
Servicing and maintenance must be carried out exclusively by suitably qualified
personnel having been authorised by the end user or the contractor of the plant.
Therefore, we recommend contacting our service.
Only perform servicing and maintenance tasks when the device is switched off.
AUMA offers extensive service such as servicing and maintenance as well as
customer product training. For the contact addresses, refer to our website
(www.auma.com).
The following actions are required to ensure safe device operation:
6 months after commissioning and then once a year
Carry out visual inspection:
Cable entries, cable glands, blanking plugs, etc. have to be checked for correct
tightness and sealing.
Consider torques according to manufacturer's details.
Check fastening screws between actuator and gearbox/valve for tightness. If
required, fasten screws while applying the tightening torques as indicated in
chapter <Assembly>.
When rarely operated: Perform test run.
In the factory, the gear housing is filled with grease.
Additional lubrication of the gear housing is not required during operation.
Perform maintenance with grease change after approximately 5 years.
We recommend replacing the seals when changing the grease.
After maintenance, perform leak tightness test at actuator and electrical connec-
tions.
The mobile PV 1691 leakage tester by AUMA can be used for leak tightness
test.
Our devices have a long lifetime. However, they have to be replaced at one point in
time. The devices have a modular design and may, therefore, easily be separated
and sorted according to materials used, i.e.:
electronic scrap
various metals
Plastic materials
Greases and oils
The following generally applies:
Greases and oils are hazardous to water and must not be released into the
environment.
Arrange for controlled waste disposal of the disassembled material or for sep-
arate recycling according to materials.
Observe the national regulations for waste disposal.
SAR 16.2-UW Control unit: electronic (MWG)
AC 01.2 Non-Intrusive Profinet