Table of Contents
Advertisement
3 Part 3 - Traditional wheel end with 3-4 planets
Spindle fitted with screws
Fig. 3.19
Fig. 3.20
Fig. 3.21
76
Meritor Wheel end assembly
19. If an ABS sensor is fitted on the axle, proceed as shown here
below otherwise move to point 23.
20. Insert the ABS sensor completely in the bushing and after that
in the appropriate bracket. - Fig. 3.19
21. Fit the bracket with the sensor in place. Fig. 3.20
22. Apply the appropriate brackets to guarantee the correct
passages to the ABS cable. - Fig. 3.21
23. Thoroughly grease the spindle bearing journals and locate the
hub in position on the spindle without the external bearing.
Fig. 3.22
NOTE
: If available, use a lifting tool.
WARNING:
Do not damage the thread of the wheel end spindle.
24. Fit the external wheel bearing. Fig. 3.23
Fig. 3.22
Fig. 3.23
Advertisement
Table of Contents
