Table of Contents
Advertisement
3 Part 2 - Traditional wheel end with 3-4 planets
Spindle fitted with interference
Fig. 3.1
Fig. 3.2
Fig. 3.3
48
Meritor Wheel end assembly
Wheel end assembly
NOTE
: Ensure mating surfaces of hub and axle shaft have been
O Ring
cleaned thoroughly
1. Refit a new outer O-ring on the hub using grease as lubricant.
Fig. 3.1
Refit the hub assembly.
2. Thoroughly grease the spindle bearing journals and locate the
hub in position on the spindle without the external bearing.
Fig. 3.2
NOTE
: If available, use a lifting tool.
WARNING:
Do not damage the thread of the wheel end spindle.
3. Fit the external wheel bearing. Fig.3.3
4. Locate the ring gear carrier into position. Assembly ring gear
group. - Fig. 3.4 - 3.5
Fig. 3.4
Advertisement
Table of Contents
