Table of Contents
Advertisement
2 Part 1 - Hub reduction with 3 - 4 planets
Wheel end with unitized bearing
Fig. 2.12
Fig. 2.13
Fig. 2.14
Remove the ring gear group. Fig. 2.12
Remove the hub assembly. Fig. 2.13
WARNING:
Do not reuse this seal.
Remove the outer O-ring from the hub and discard. Fig. 2.14
Remove the drive shaft seal by levering out, and discard. Fig.2.15
WARNING:
Do not reuse this seal.
Hub bearings are pre-adjusted cartridge type and cannot be
individually replaced. In case of non serviceability a replacement
service exchange hub should be refitted.
O Ring
Fig. 2.15
Meritor Wheel end assembly
17
Advertisement
Table of Contents
