Table of Contents
Advertisement
2 Part 3 - Traditional wheel end with 3-4 planets
Spindle fitted with screws
Fig. 2.25
Fig. 2.26
Fig. 2.27
70
Meritor Wheel end assembly
15. Untighten and remove the spindle from the housing (Do not
remove the stud). Figg. 2.25 and 2.26
WARNING:
During the spindle disassembly the spacer may fall out. To
prevent any injury Meritor suggests to lock the spacer
securely with a screw and nut to prevent it from coming out
of the housing and falling accidentally.
16. The spacer (if present) is free and it's possible to remove it.
(Do not remove the stud).
NOTE: Scrap the original o-ring and fit a new one in the spindle
and in the spacer if it was disassembled.
NOTE: Do not remove the three studs from the housing. The studs
will be needed during the reassembly procedure.
NOTE: Check the threads on the housing. Use air flow to clean
the surface and the threads. Check the threads on the housing
again. If needed resablish the corrct functionality of the threads
with the suitable tool.
Advertisement
Table of Contents
