Table of Contents
Advertisement
3 Part 1 - Hub reduction with 3 - 4 planets
Wheel end with unitized bearing
Apply sealing compound in approx. 6mm diameter.
Bead (Dow Corning 7091) to the inner face of the cover plate in a
continuous bead (as showed between internal circumference ribs
and holes). Fig. 3.21
The components must be assembled immediately to permit the
silicone gasket material to compress evenly between the mating
surfaces. Refit the cover plate on the end of the hub casing and
retain with screws. Torque: 20 ± 5Nm
Fig. 3.22
Fill hub with 2.5 litres of oil as specified by vehicle manufacturer.
Fit new oil drain plug. Torque: 80Nm ± 20Nm
Fig. 3.23 - Hollow shaft
Fig. 3.24 - Solid shaft
NOTE
: with new hub cap there is an oil level line that aligns with
the bottom of the filler hole. When line is horizontal it is an
indication of permitted oil capacity.
Hollow shaft
Fig. 3.23
Fig. 3.21
Fig. 3.22
Solid shaft
Fig. 3.24
Meritor Wheel end assembly
29
Advertisement
Table of Contents
