Table of Contents
Advertisement
3 Part 3 - Traditional wheel end with 3-4 planets
Spindle fitted with screws
Fig. 3.1
Fig. 3.2
Fig. 3.3
72
Meritor Wheel end assembly
Wheel end assembly
NOTE: Ensure that mating surfaces of hub and axle shaft have
been cleaned thoroughly.
1. Tighten the stud on the axle.- Fig. 3.1
2. Assembly the new o-ring in the slot of the spacer - Fig. 3.2
3. Apply grease on the joint surface. - Fig. 3.3
4. Put the spacer (if needed according to the axle variant) in
position - Fig. 3.4
WARNING:
Do not damage the o-ring present in the spacer.
Fig. 3.4
Advertisement
Table of Contents
