Table of Contents
Advertisement
2 Part 3 - Traditional wheel end with 3-4 planets
Spindle fitted with screws
Fig. 2.21
Fig. 2.22
Fig. 2.23
11. Untighten the lever pinch bolt/nut from the lever. - Fig. 2.21
Remove the clevis from the lever/pushrod (M10x1.5). Discard
& Scrap the nut.
12 Remove the lever - Fig. 2.22
13. Remove the brake and the spindle. - Fig. 2.23
14. Untighten and remove the brake from the spindle.
(Screw M16x2). Discard & Scrap the screw. - Fig. 2.24
WARNING:
To avoid any problems on the thread it is advised not to use
any electric or pneumatic screwdrivers.
If the green o-ring has a mark, discard and scrap it.
Fig. 2.24
Meritor Wheel end assembly
69
Advertisement
Table of Contents
