Table of Contents
Advertisement
2 Part 3 - Traditional wheel end with 3-4 planets
Spindle fitted with screws
Fig. 2.13
Fig. 2.14
Fig. 2.15
5. Remove the hub Fig. 2.13 and check the green o-ring in the
back side. - Fig. 2.14
NOTE
: If available, use a lifting tool.
WARNING:
Do not damage the thread of the wheel end spindle.
WARNING:
If the green o-ring has a mark, discard and scrap it.
6. If the axle has an ABS sensor proceed as shown here below
otherwise move to point 10.
7. Disconnect ABS sensor cable completely and remove it.
8. Untighten the brackets. Fig. 2.15
O Ring
9. If needed, replace the ABS sensor. Figg. 2.16-2.17
Fig. 2.16
Fig. 2.17
Meritor Wheel end assembly
67
Advertisement
Table of Contents
