Table of Contents
Advertisement
3 Part 3 - Traditional wheel end with 3-4 planets
Spindle fitted with screws
Fig. 3.9
Fig. 3.10
Fig. 3.11
74
Meritor Wheel end assembly
9. Tighten the new brake screw manually (do not close at final
torque). - Fig. 3.9
10. Insert the lever in correspondence of the previously marked
done - Fig. 3.10
11. Insert the clevis in correspondence of the previously marked
done - Fig. 3.11
12. If needed adjust the lever position but do not close the new
screw yet. - Fig. 3.12
13. If needed, adjust the clevis position on the air chamber
pushrod but do not close the new screw yet. - Fig. 3.13
Fig. 3.12
Fig. 3.13
Advertisement
Table of Contents
