Meritor MM-0164 Maintenance Manual page 14

2 Part 1 - Hub reduction with 3 - 4 planets
Wheel end with unitized bearing
Fig. 2.1
Fig. 2.2
Fig. 2.3
14 Meritor Wheel end assembly
Disassembly
Remove the wheel nuts and retain. Pull off the wheels using a
wheel trolley. Remove the air inflation valve from its retainer in the
inside wheel.
Jack up the rear axle of the vehicle to vehicle manufacturers
recommendations and drain the oil from the axle(s). Fig. 2.2
Remove the hub drain plug and discard.
Drain oil from wheel end. Fig. 2.3
Tighten in dedicated holes the tool's screws equally and
simultaneously, and avoid using excessive force as this could
damage the drum. Fig. 2.4
A soft-faced mallet may be used on the drum to loosen and ease
withdraw.
Fig. 2.4