Connections; Control Devices - FAAC B614 Manual

5.2 CONNECTIONS

F
Before making electrical connections, turn off power
to the barrier. If the disconnect switch is not in
view, apply a warning sign stating "WARNING - Main-
tenance in Progress".

In Master-Slave configuration see the chapter § 9.

CONTROL DEVICES

(31) Connect the devices to the terminal block J6
of the board.

Multiple NO contacts on same input must be con-
nected in parallel. Multiple NC contacts on same input
must be connected in series.
TERMINAL BLOCK J6:
NO contact, connect a pushbutton or other pulse
1 OPEN generator that commands the opening of the barrier,
by closing a contact
NO contact, connect a pushbutton or other pulse
2 CLOSE generator that commands the closing of the barrier,
by closing a contact
Configured as STOP
NC contact, connect a pushbutton or other pulse
generator that commands the stopping of the barrier,
STOP
by opening a contact

If NO device is connected, jump the
input to
3
Configured as FSW-CL
programming):
NC contact, connect a photocell or other device that
commands the inversion on opening, by opening a
FSW-CL
contact during closing

If NO device is connected, jump the
input to
NC contact, connect a pushbutton or other pulse
generator that commands the emergency opening of
the barrier, by opening a contact
4 EMER

If NO device is connected, jump the
input to
Accessories power supply negative and common
7 GND
contact (1 A max.)
Accessories power supply positive 24 V " (1 A max.).
8-9 +
STOP input configured as FSW-CL
The STOP input can be configured as safety (FSW-CL).
Connect the negative of the transmitter (TX)
supply of the photocells to an
as Fail-Safe. In this way the operating condition of
the photocells is checked before each closing: the
test consists in breaking the power supply to the TX
B614
(default):
GND
SP
(see function in Advanced
GND
GND
power
OUT output configured
J6
J6
RX
1
2
3
4
5
5
6
31
J20
TX
1
2
6
31
532297 - Rev.D