Installing The Barrier Body - FAAC B614 Manual

4.3 INSTALLING THE BARRIER BODY

F
Always perform the work with the power supply
disconnected.
!
Before you start, make sure that the plinth's concrete
has solidified.
In this phase the barrier must be locked.
Never handle the barrier by holding the control
board support.
1. ( 1 0 ) Remove the 4 nuts with washers from
the plate
2. (1 1 ) Place the barrier body on the foundation,
at the four mounting holes.
!
Be careful not to damage the electrical cable conduits.
3. (12) Fix the body of the barrier in position using
a nut with washer on every bolt of the foundation.
!
Use the torque wrench to tighten to the torque shown
in the figure.
B614 19
1 0
1 1
50 Nm
19
1 2
532297 - Rev.D