Accessories; Flashing Light; Xf Radio Module - FAAC B614 Manual

8. ACCESSORIES

!
When working inside the enclosure there are risks of
cutting, shearing, crushing hands due to the presence
of moving parts. Until the installation is completed,
the partially installed barrier must always be left
locked and with the door and upper cover always
closed to prevent access to the electronic parts and
the moving mechanical pars.
Never install the arm before securing the barrier body
and checking it. Until the installation is complete
never leave the barrier unattended with the arm
installed. Mark off the work site and prohibit access/
transit. If installation is outside, it must be done in
good weather without rain or gusts of wind. If it is
raining, an adequate shelter for the barrier must be
made until the mechanical and electronic installation
is complete.
Never handle the barrier by holding the board
suppoort.
"
8.1 24V

FLASHING LIGHT

The flashing light indicates that the automation is
moving.

Install the flashing light in an easily visible position.
1. ( 3 9 ) Connect the flashing light to terminal
block J16 (3 W max).
2. If required, set the preflash (
gramming)
3. Check that the device is working properly.

8.2 XF RADIO MODULE

The E614 is equipped with an OMNIDEC integrated
two channel decoding system that can program, via
the XF radio module, the FAAC radio controls trans-
mitters codes

A maximum of 256 codes can be stored.
The stored codes act as an
The radio controls and the XF radio module must have
the same frequency.
When storing the codes, keep the radio control
approximately 3 ft (1m) from the XF radio module.
1. (40) Insert the XF radio module in the connec-
tor J3 paying attention to the insertion direction.
2. Store the radio controls.
B614
PF
Advanced pro-
OPEN or CLOSE command.
LC/RC - STORE THE FIRST RADIO CONTROL
1. Press and keep pressed the + key
ming) or - (CLOSE
the button for about 5 seconds, the corresponding
radio LED (DL4 or DL5) will start to flash to indicate
that the radio code learning phase has started.
2. Release the button, from this moment E614 stays
in the learning phase for around 20 secs.
3. Make sure that the LED DL4 or DL5 on the board
is still flashing and press the button of the LC/RC
radio control that you wish to store for a few sec-
onds (the LED becomes steady).
or DL5) on the board goes on as a steady light for
1 sec to then start flashing again for another 20
seconds during which it is possible to store another
radio control.
4. To store additional radio controls at a later stage,
repeat the procedure from the beginning or carry
out the remote code storing procedure.
41
J16
(OPEN program-
programming). After pressing
The LED (DL4
532297 - Rev.D
39
40