Diagnostics; Leds Check; Direction Of Movement Check; Encoder Operation Check - FAAC B614 Manual

10. DIAGNOSTICS

10.1 LEDS CHECK

LED
DL1 BUS
DL2 BUS MON
DL3 RADIO1
DL4 RADIO2
DL5 Error/alarm "ERROR"
DL8 EMER
DL9 STOP
DL10 CLOSE
DL11 OPEN
DL12 LOOP1
DL13 LOOP2
 
In Master-Slave configuration see the chapter § 9.

10.2 DIRECTION OF MOVEMENT CHECK

1. Select parameter
ming. The display shows
+
2. Keep the button pressed. The display shows
oP
and the barrier opens.
3. Keep the - button pressed. The display shows
cL
and the barrier closes.
4. If the conditions in points 2 and 3 are not respect-
ed, invert the motor wires.

10.3 ENCODER OPERATION CHECK

M1
1. Select parameter
--.
display shows
+
2. Keep the button pressed. The display shows
oP
and the barrier opens. The flashing point
between the two letters indicates that the encoder
is operating correctly.
3. Keep the - button pressed. The display shows
cL
and the barrier closes. The flashing point
between the two letters indicates that the encoder
is operating correctly.
B614
STATUS IDLE
 
active
 not active

See BUS 2easy device
registration
 
active
 not active
 
active
 not active
 
active
 not active
 
not active
 active
 
not active
 active
 
active
 not active
 
 
active
 not active
 
active
 not active
M 1
in the Basic program-
--.
in Basic Programming, the
10.4 AUTOMATION SYSTEM STATUS
CHECK
The E614 display if not in the programming, shows a
code indicating the status the automation is in:
00 Closed
01
Open
02
Stationary then opens
03
Stationary then closes
04
In pause mode
05
Opening
06
Closing
07 Failsafe in progress
08 BUS 2easy device verification in progress
09
Pre-flashing and then opens
10
Pre-flashing and then closes
11
Opening in Emergency

10.5 CHECK FIRMWARE VERSION

When the display of the E614 is switched on, it shows
the following in succession:
- firmware version (2 digits separated by a point)
- automation system status
10.6 CHECK OF THE REGISTERED
BUS 2EASY DEVICES
1. Select parameter
2. Press and hold the
to the registered devices will light up (see  48).
49
bu
in Basic programming.
+
button; the segments relative
532297 - Rev.D