Single Spring; Double Spring - FAAC B614 Manual

SINGLE SPRING

1. Lengthen the turnbuckle by manually unscrewing
it to facilitate the operation.
2. (23) Hook the spring onto the turnbuckle and
the appropriate slot at the bottom of the barrier
body (see  2).
3. Shorten the turnbuckle by rotating it manually to
place the spring under tension.
!
Keep away from the spring coils.
B614

DOUBLE SPRING

1. Lengthen the turnbuckle by manually unscrewing
it to facilitate the operation.
2. Lower bracket (24): Connect the plate 1 to the
slot on the base of the barrier body as shown in
the figure and lock it in position using the part 2.
Attach the 2 springs.
3. Upper bracket ( 2 4 ): Attach the plate 2 to the
springs and then to the turnbuckle.
4. Shorten the turnbuckle by rotating it manually to
place the spring under tension.
!
Keep away from the spring coils.
 2 3
24
1
2
24
532297 - Rev.D