Slave Barrier Configuration - FAAC B614 Manual

SLAVE BARRIER CONFIGURATION
1. Power Slave barrier The board turns on. The
display reads in sequence:
- firmware version (2 digits separated by a point)
-
SO
flashing if a set-up or the automation status
is requested
2. Access the Basic programming and set:
-
cF
depending on the arm configuration and length
-
Ct SL
= for configuring the board as
3. Check the status of the LEDs on the board:
LED DL7 (Red)
Master-Slave
 
is short circuited.
LED DL3 (Green)
 
Master-Slave
4. Check the direction of travel (see the chapter §
10.2). The barrier must not be in manual func-
tioning mode.
5. Start up (see the chapter § 6).
 
During the set-up the
board and the two arms move with a synchronous
movement.
B614
Slave.
synchronisation absent or the line
synchronisation present.
Master board controls the Slave
48 532297 - Rev.D