External Loops; Bus Devices; Out Outputs; Flashing Light - FAAC B614 Manual

momentarily and checking the change of status of the
input. If the test fails the electronic board does not
command the movement.

EXTERNAL LOOPS

!
The magnetic loop detectors must not be used to
detect pedestrians, cycles and motorbikes. If it
necessary to detect them, other devices such as
photocells are needed.
( 3 2) Connect the magnetic detectors to terminal
boards J10 (LOOP 1) or J13
Opening coil NO contact
LOOP 1
Connect a detector that, when the contact is closed (loop
engaged), commands the opening
Transit coil NO contact
Connect a detector that, when the contact is closed (loop
engaged), works according to the set functioning logic:
all logics, except P As long as the loop is engaged,
it prevents closing. If the loop is engaged during the
LOOP 2
closing, it commands the inversion on opening.
only in logic P The loop commands the closing at the
disengagement. If the loop is engaged during the
closing, it commands the stop (disengage the loop to
complete the closing)

BUS DEVICES


If no BUS 2easy devices are used, leave the BUS 2easy
terminal board free.
See the chapter § 8.4 for the connection and
orientation.
OUT OUTPUTS

Do not exceed 100mA max load for each output.
Open Collector Outputs: the activation of the output
and its polarity can be configured by Advanced pro-
gramming.
OUT active
0 V "
NO polarity
NC polarity open circuit
( 3 3 ) Connect the devices required to terminal
block J20.
"
24 V

FLASHING LIGHT

See the chapter § 8.1 for the connection.

MOTOR

(34) The motor wire is connected from the factory
for a RH barrier.
Invert the wires if a LH barrier is being installed.
B614
(LOOP 2).
OUT not active
open circuit
0 V "
J10
J20
red
M
blue
32
J13
32
J3
33
AC MAI
MOT
J23
MOT
J11
ENC
34
532297 - Rev.D