Electronic Installation; Board E614; Components; E614 Board Technical Data - FAAC B614 Manual

5. ELECTRONIC INSTALLATION

F
ALWAYS DISCONNECT THE POWER SUPPLY before
working on the board. Turn power on only after
having made all the electrical connections and carried
out the preliminary start-up checks.
The board cover must never be removed unless the
board is to be replaced. No installation operation
requires the removal of the cover.

5.1 BOARD E614

 4 E614 board technical data
Power supply voltage
Max power
Accessories output voltage
Max. accessories load
Max. BUS 2easy accessories load
Max. flashing light load
Ambient operating temperature

COMPONENTS

See figure  3 0
BOARD:
J1 Mains power supply terminal block
J3 BUS 2easy terminal block
J6 Inputs terminal block
J7 Connector for XF radio module
J8 Connector for battery backup
J10 Terminal block for external detector
J11 Connector for encoder
J13 Terminal block for external detector
J16 Terminal block for external flashing light
J18 Terminal block for the arm lights
J20 Terminal block for outputs
J21 Connector for integrated flashing light
J23 Connector for motor
F1 Board protection fuse (F1 = T5A UL approved)
DISPLAY Programming display
DL1 BUS 2easy ACTIVE LED
B614
BOARD:
DL2
DL3
DL4
DL5
DL8
LOOP1
DL9
DL10
LOOP2
DL11
DL12
DL13
29
115V~ +/-10% 50/60 Hz
150 W
24 V "
500 mA
500 mA
24 V " 15 W
-4 ° to +131 °F (-20 °C to +55 °C)
BUS 2easy "BUS MON" diagnostic LED
"RADIO1" (OMNIDEC) LED
"RADIO2" (OMNIDEC) LED
Error / alarm LED
EMER status LED
STOP/FSW-CL status LED
CLOSE status LED
OPEN status LED
LOOP1 status LED
LOOP2 status LED
532297 - Rev.D