FAAC B614 Manual page 39

Advanced function
P1
OUT OUTPUT 1 POLARITY
Y
NC output
no
NO output
o1 01
If output = (Fail-safe) configure
o2 o1
see
P2 P1
see
o3 o1
see
P3 P1
see
o4 o1
see
P4 P1
see
to
OUT OUTPUT 1 TIMING
(only displayed if one of the outputs is configu-
red as courtesy light)
This defines the timing of the output from 1 to 59
minutes in 1 minute steps.
bF
BATTERY OPERATION
01
continues to function until completely dead
02
the barrier opens when the mains power is
interrupted
03
the barrier closes when the mains power is
interrupted
oS
INTEGRATED flashing light OPERATING MODE
01
light column (steady green with barrier in
pause mode/open, red flashing during movement,
red steady with barrier closed)
02
flashing light (flashing red during move-
ment, off in all other states)
bL
ARM LIGHT OPERATIONAL MODE
01
lights on with barrier closed, off with barrier
in pause mode/open, flashing during the move-
ment
02
lights off with barrier in pause mode/open,
flashing in all other states
AS
MAINTENANCE REQUEST - CYCLE COUNTER (linked
to the next two functions)
This can be useful to set scheduled maintenance
interventions.
Y
Active
no
Excluded
nc CYCLE PROGRAMMING IN THOUSANDS
This makes it possible to set a countdown of the
plant operating cycles from 0 to 99 (thousands of
cycles). The function can be used, in combination
nC
with , to verify the use of the system and for
the "Request for assistance"
00 99
... (thousands of cycles)
B614
Default Advanced function
no nC
P1 no
= .
St
02
01
01
01
no
00
37
CYCLE PROGRAMMING IN HUNDREDS OF THOU-
SANDS
This makes it possible to set a countdown of the
plant operating cycles from 0 to 99 (hundreds of
thousands of cycles). The value displayed is updated
a the cycles progress, integrating with the
nC
(1 decease corresponds to 99
The function can be used in combination with
nc
, to verify plant use and for the "Request for
Assistance".
AUTOMATION SYSTEM STATUS:
St
See in the Basic programming
Default
00
nc
value.
nc
decreases).
Y
532297 - Rev.D