Table of Contents
Advertisement
3.6 TECHNICAL CHARACTERISTICS
The cylinder is moved by an internal hydraulic unit. A release device, protected by a security lock, to lower the cylinder can be accessed
from the top. The thrust capacitor is pre-wired and housed in the internal junction box.
Certifications The J275 HA 2K20 bollard is certified according to the following standards and relative performance levels:
- PAS 68:2013
V/7500 (N2)/48/90:1.7/0.0
- IWA 14–1:2013
V/7200 [N2A]/48/90:1.9
Optional equipment
- Emergency lowering device: a solenoid valve connected to the mains power supply allows the cylinder to be lowered automatically in
the event of a power failure.
- Obstacle detection device: allows the closing movement to be reversed if an obstacle (e.g. a vehicle) is detected.
3.7 COMPONENT IDENTIFICATION
1
15
14
13
12
16
J275 HA 2K20
1
Flashing LED light
2
2
Head
3
Oil filler plug
4
Hydraulic unit lifting handle
5
Hydraulic unit
3
6
Top cover
7
High position magnetic contacts (1 NC / 1 NO)
8
Sliding guides
4
9
Frame
10 Low position mechanical stops (4)
11 Low position magnetic contact (N.C.)
5
12 High position mechanical stops (4)
13 External junction box
14 Cylinder
15 Internal junction box
6
16 Head removal key
INSTALLATION ACCESSORIES (SUPPLIED SEPARATELY)
Pit
7
8
9
10
1
Subframe
11
2
Side module with cable routing hole (x1)
3
Cable gland
4
Side module (x7)
5
Base with water drainage holes
7
1
2
3
4
5
2
532270 - Rev.A
Advertisement
Table of Contents
