Procedure Summary - Nortel Meridian 1 Administration And Maintenance

Page 466 of 492

Procedure summary

553-3011-311 Standard 7.0
Appendix A — 2Mb PRI implementation
Step Overlay
1 LD 17 (CFN)
2 LD 17 (CFN)
3 LD 15 (CDB)
4 LD 16 (RDB)
5 LD 14 (TDB)
6 LD 73 (PRI2)
7 LD 73 (PRI2)
8 LD 73 (PRI2)
1 Add a PRI loop. Use Overlay 17.
Prompt Response
REQ CHG
TYPE CFN
CEQU YES
PRI2 XXX
MODE PRA
2 Add a DCHI or DDCH. Use Overlay 17.
Prompt Response
REQ CHG
TYPE CFN
ADAN NEW DCH
1-15
CHG DCH
1-15
Out DCH
1-15
May 1999
Action
Add a PRI loop.
Add a DCHI/DDCH card.
Define a PRI customer.
Define a PRI service route.
Define service channels (B channels) and PRI
trunks.
Define clock controller parameters.
Define PRI parameters and thresholds.
Change trunk pad category values. In most
cases, the settings should be left at their default
values. However, if changes to these values are
necessary, use this step to make them.
Description
configuration data block
changes to common equipment
where XXX is the DTI/PRI digital card number
(1-9)
select Primary Rate Interface mode
Description
Configuration data block
Add a primary D-Channel port number. Any
unused SDI port number
Change a primary D-Channel
Out the primary D-Channel