Nortel Meridian 1 Administration And Maintenance page 242

Page 228 of 492
Prompt
DES
CUST
CTYP
MISP
MODE
B1CT
553-3011-311 Standard 7.0
Chapter 5 — ISDN BRI line and packet data implementation
Response Comment
x...x Designator you assign to a DSL
(example, BUILD2)
The values for this prompt are:
x...x=1 to 6 alphanumeric DSL designator
0-31 Customer number
SILC,UILC SILC or UILC line card
Note: This prompt is displayed only if the SILC or UILC has
not been previously configured, or if another DSL has not
been configured on the same SILC/UILC.
1-9 MISP card slot number
This prompt is displayed only if the MISP has not been
assigned to the specified SILC or UILC.
NTAS,NTFS Network terminal line sampling mode
The values for this prompt are:
NTAS=Adaptive sampling
Extended passive bus, Branched passive bus,
Point-to-point bus
NTFS=Fixed sampling
Short passive bus
This prompt is displayed only if you specified the card type
as SILC and defaults to NTAS.
B-channel 1 call type.
(VCE) (DTA) VCE = Circuit switched voice
PMD DTA = Circuit switched data
XPMD PMD = B-channel packet data with dedicated connection
from DSL to a PRI channel using external packet handler.
For B1CT = PMD, B-channel packet data must have been
specified at the PH prompt in LD27.
PMD cannot be combined with any other options.
Do not select <cr> which defaults to VCE (circuit switched
voice) and DTA (circuit switched data) which may not run
concurrently with packet data.
XPMD = Delete PMD call types.
Enter <cr> to select voice and data as defaults.
May 1999