Nortel Meridian 1 Administration And Maintenance page 232

Page 218 of 492
553-3011-311 Standard 7.0
Chapter 5 — ISDN BRI line and packet data implementation
Initializing a Northern Telecom M5317TDX terminal
The following is an example of the steps to follow to initialize an M5317TDX
terminal. Table 16 is a list of error codes that may appear during terminal
initialization and their meaning. Additional information is contained in the
M5317TDX user guide.
1 Set the switch on the bottom of the terminal for either line power or
local power.
2 Plug in the M5317TDX terminal while holding down the RLS and
HOLD keys as it powers up.
3 Press MAINROM.
4 Press INSTALL.
5 Press ENGLISH or FRANCAIS for your choice of language.
6 Press the soft key of the TEI you want to set PHONE, DATA or X25.
Note: With minimum firmware version 2.0 only dynamic TEI is
supported.
• Enter * for dynamic TEI.
• Enter the TEI on the terminal keypad for static TEI.
7 Press OK when you have finished setting the TEIs.
8 Enter the phone (voice) SPID. Press OK when finished.
9 Enter the data SPID. Press OK when finished.
10 Enter the data DN. Press OK when finished.
11 Press HEADSET until REAR is displayed.
12 Press SIGTYPE until MER1 is displayed.
13 Press A/MU until MU-LAW is displayed.
14 Press MORE.
15 Press DIALPLN until NATIONAL is displayed.
16 Press EXIT.
17 Press NO for execute SPM.
May 1999