Nortel Meridian 1 Administration And Maintenance page 348

Page 334 of 492
Prompt
B1CT
B2CT
LDN
XLST
MTEI
553-3011-311 Standard 7.0
Chapter 8 — Service changes and maintenance
Response Comment
VCE DTA PMD B-channel 1 call type
XVCE XDTA The values for this prompt are:
XPMD VCE=Adds circuit switched voice.
DTA=Adds circuit switched data
PMD=Adds packet mode data (B-channel packet data
must have been specified in the MISP configuration
procedures ).
XVCE=Removes circuit switched voice
XDTA=Removes circuit switched data
XPMD=Removes packet mode data (B-channel packet
data must have been specified at the PH prompt in the
MISP configuration procedures )
You can enter more than one B-channel call type by
separating each entry with a space. You cannot select
PMD simultaneously with VCE and/or DTA.
VCE DTA PMD B-channel 2 call type
XVCE XDTA The values for this prompt are:
XPMD VCE=Adds circuit switched voice
DTA=Adds circuit switched data
PMD=Adds packet mode data (B-channel packet data
must have been specified at the PH prompt in the MISP
configuration procedures )
XVCE=Removes circuit switched voice
XDTA=Removes circuit switched data
XPMD=Removes packet mode data
You can enter more than one B-channel call type by
separating each entry with a space. You cannot select
PMD simultaneously with VCE and/or DTA.
0-3,NO Departmental listed directory number
The values for this prompt are:
0-3=Listed directory number 0, 1, 2, or 3 specified in
Customer Data Block Program LD 15
NO=No listed directory number associated with this
DSL
0-254 Pretranslation group. This prompt comes up if
configured in customer data block
1-(8)-20 Maximum number of Terminal Endpoint Identifiers
Both static and dynamic combined.
May 1999