Nortel Meridian 1 Administration And Maintenance page 314

Page 300 of 492
Prompt
ROUT
B1
MEMB
TGAR
NCOS
CLS
553-3011-311 Standard 7.0
Chapter 6 — ISDN BRI trunk implementation
Response Comment
0-511 Route number for the trunk DSL. The specified route
must match the ISDN BRI trunk type specified at the
TKTP prompt.
If the DSL is in the NET mode (MODE = NT in LD 27),
the entered route must be NET side (SIDE = NET in LD
16).
YES/(NO) Configure B Channel 1.
If REQ = NEW, a response to this prompt is not
required, because B1 parameters are mandatory. The
system will display the following prompts.
1-254 Route member number to be associated with B-channel
1.
(0)-31 Trunk Group Access Restriction.
(0)-99 Network Class of Service Group Number
aaa Class of Service options.
Possible inputs are as follows:
APN = ACD Priority not allowed
APY = ACD Priority allowed
UNR = Unrestricted (default)
CTD = Conditionally Toll Denied (valid for TIE trunks
only)
CUN = Conditionally Unrestricted (valid for TIE trunks
only)
FR1 = Fully Restricted class 1 (valid for TIE trunks only)
FR2 = Fully Restricted class 2 (valid for TIE trunks only)
FRE = Fully Restricted (valid for TIE trunks only)
SRE = Semi-Restricted (valid for TIE trunks only)
TLD = Toll Denied (valid for TIE trunks only).
MRA = Message Registration Allowed (assigning
meters to ISDN BRI sets, for Advice of Charge for
EuroISDN, APAC (Australia and Japan), or
Australia-AXE and Japan D70).
MRD = Message registration denied.
PGNA = Call Page Network Wide Allowed.
(PGND) = Call Page Network Wide Denied.
CUN, CTD, TLD, SRE, FRE, FR1, and FR2 are allowed
only for TIE trunks.
Input is accepted until <cr> is entered.
May 1999