Nortel Meridian 1 Administration And Maintenance page 313

Prompt Response
MODE TE/NT
MTFM YES/(NO)
TKTP TIE/COT/
DID
CLOK YES/(NO)
TSET (0)-15
PDCA (1)-16
Chapter 6 — ISDN BRI trunk implementation
Comment
The mode for the trunk DSL.
TE is entered for Terminal Equipment,
NT is used for Network Termination.
See the Trunk configuration figures earlier in this
chapter to determine the Mode to be set based on the
configuration you are implementing.
This prompt is displayed only if SILC was specified as
the card type. For UILC, this entry defaults to NT
mode. For SILC, the default is TE.
Note: Cannot change MODE from TE to NT if clock on
DSL is referenced in the digital data block or DTI2/PRI2
system data. The reference must first be removed. If
MODE is set to NT, CLOK will be set to NO.
Enable/Disable multi-frame option. Prompted only if
MODE=TE
If enabled this prompt allows you to receive more
diagnostic messages.
Trunk type
Whether this trunk DSL is provisioned for clock source.
The SILC must be residing in slot 1-10 in the main
cabinet.
This prompt appears if the following conditions are met:
- the card type is SILC
- the DSL# is 0 or 1
- the trunk DSL has been defined as TE mode
Note: The clock prompt cannot be changed from YES
to NO if the clock on the DSL is referenced in the Digital
Data Block or the DTI2/PRI2 system data. The
reference must first be removed.
Clock error threshold set
Note: The threshold Set is currently not used. Press
<cr> to accept the default 0 value.
Pad table number (previously configured in LD 73) to
be associated with this DSL
Option 11C ISDN BRI Administration and Maintenance
Page 299 of 492