Nortel Meridian 1 Administration And Maintenance page 249

Chapter 5 — ISDN BRI line and packet data implementation
Prompt Response
DN xxxx (0)-N
<cr>
CT VCE DTA
MCAL 1-(4)-8
PRES (YES),NO
COLP (NO) YES
TRANS (NO) YES
Comment
Directory number to be associated with the TSP
xxxx = DN to be associated with the TSP.
(0)-N = CLID entry, with N = CLID SIZE-1 (SIZE defined
in LD 15).
<cr>=Stops this prompt from being displayed again
The directory number assigned cannot be shared by a
non-BRI terminal.
This prompt is repeated until <cr> is pressed. At least
one and a maximum of 8 DNs can be assigned to a
DSL.
The directory number can be associated with multiple
TSPs on a DSL but it cannot be associated with any
other DSL.
This prompt defines the call type to be associated with
the Directory Number.
The values for this prompt are:
VCE=Circuit switched voice
DTA=Circuit switched data
One or more call types can be entered by separating
each entry with a space.
Note: The call types entered must have been specified
for the B1CT and B2CT prompts in the DSL
configuration procedures .
Maximum number of calls per DN at one time
Defines the maximum number of calls allowed for a
directory number. This total represents the sum of
active calls, calls waiting, and calls on hold.
Allows display of calling line identification to far end on
outgoing calls.
YES= allows this DN to be presented to the called party
on outgoing calls
NO= do not present this DN to the called party on
outgoing calls
Connected Number Information Elements (IEs) is (not)
passed from the Meridian 1 to the Terminal Adapter
(S ).
o
CLID and Connected Number Information Element (IE)
are (not) passed from the Meridian 1 to the Terminal
Adapter (S ), if presentation is restricted.
o
Option 11C ISDN BRI Administration and Maintenance
Page 235 of 492