Nortel Meridian 1 Administration And Maintenance page 73

LD 27 – Administer the Terminal Service Profiles (TSPs) on a Digital Subscriber
Loop (DSL).
Prompt Response
REQ NEW
CHG
TYPE TSP
DSL c dsl#
USID 0-15
SPID aaa...a <cr>
Xaaa...a
...
Chapter 2 — Feature descriptions
Description
Add a TSP.
Change a TSP.
Administer the TSP on a DSL.
DSL location.
User service identifier
Set USID = 0 to configure a default TSP for
non-initializing terminals.
Set USID = 1-15 for initializing terminals, for example,
the M5317TDX.
Service profile ID
aaa...a = any combination of one-20 alphanumeric
characters.
<cr> = Stops this prompt from being displayed again. A
maximum of 8 valid SPIDs per TSP are allowed.
This prompt appears only if USID = 1-15 (if 0 was
entered for the USID, a SPID is not required). This SPID
must be programmed in the initializing terminal to
associate the terminal with a USID. Refer to the note
which follows on page 59.
Xaaa...a = removes the specified SPID.
Note: The ISDN BRI terminal requires that Layer 2 and Layer 3
parameters be programmed at the terminal. When programming the
SPID, the voice SPID and data SPID should each match the one entered
in LD 27 when administering the TSP which contains the terminal's DN.
Also, if the terminal has an option to select the standard protocol, select
the NI-1 standard. Refer to your terminal documentation for complete
instructions.
Option 11C ISDN BRI Administration and Maintenance
Page 59 of 492