Ni-1 Bri Compliance Enhancements - Nortel Meridian 1 Administration And Maintenance

Page 58 of 492
Chapter 2 — Feature descriptions

NI-1 BRI Compliance Enhancements

553-3011-311 Standard 7.0
This feature enhances the Meridian 1 functional protocol to be compatible
with the National ISDN-1 (NI-1) ISDN Basic Rate Interface (BRI) voice and
data standard for line application. The NI-1 protocol is configured in Overlay
27, which is used for ISDN BRI administration, by entering "6" against the
PRID prompt. This protocol information is downloaded to the Multi-purpose
ISDN Signaling Processor's (MISP) network layer for handling ISDN BRI
line application interface with NI-1 compatible terminals.
Another enhancement introduced by this feature is that the alphanumeric
value for the Service Profile Identification (SPID) has been expanded from
9 to 20 characters (although the NI-1 standard only requires that the SPID
range be from 9-20, the Meridian 1 implementation supports 1-20). The SPID
is configured in Overlay 27 (by administering the Terminal Service Profiles)
for the network side, and programmed on NI-1 compatible ISDN BRI
terminals for the user side (both entries for the SPID must be the same).
Operating parameters
There are no operating parameters for this feature.
Feature interactions
There are no feature interactions for this feature.
Feature packaging
The following packages are required:
— ISDN Basic Rate Interface (BRI) package 216
— ISDN BRI Line application (BRIL) package 235
— Multi-purpose Serial Data Link (MSDL) package 222
Programming procedures for NI-1 BRI Compliance
Enhancements
The following steps should be used to configure NI-1 BRI Compliance
Enhancements:
1 Administer the TSP for a DSL using LD 27.
2 Configure the NI-1 protocol for a DSL using LD 27.
May 1999