Operating Modes; Power Supply - Quectel RM500Q-AE Manual

NOTE
1.Keep all NC, reserved and unused pins unconnected.
、
2.Pinpin 61/ and Ppin 63

3.3. Operating Modes

The table below briefly summarizes the various operating modes to be mentioned in the following
chapters.
Table 5: Overview of Operating Modes
Mode Details
Idle
Normal
Operation
Talk/Data
Minimum AT+CFUN=0 command sets the module to a minimum functionality mode without
Functionality removing the power supply. In this mode, both RF function and (U)SIM card are
Mode invalid.
AT+CFUN=4 command or driving
Airplane Mode
airplane mode. In this mode, the RF function is invalid.
In this mode, the current consumption of the module is reduced to the minimal level,
Sleep Mode while the module keeps receiving paging messages, SMS, voice calls and TCP/UDP
data from the network.
In this mode, the power management unit shuts down the power supply. Software is
Power Down
inactive, the serial interfaces are inaccessible, and the operating voltage (connected to
Mode
VCC) remains applied.
3.3.3.4.

Power Supply

The following table shows pin definition of VCC pins and ground pins.
Table 665: Definition of VCC and GND Pins
Pin No.
RM500Q-AE&RM502Q-AE_Hardware_Design
isare used for ANTantenna
Software is active. The module has registered on the network, and it is
ready to send and receive data.
The module is connected to network. In this mode, the power
consumption is decided by network setting and data transfer rate.
Pin Name
RM500Q-AE&RM502Q-AE Hardware Design
tuner
W_DISABLE1#* pin low will set the module to
I/O Power Domain
5G Module Series
Description
26 / 83