Table of Contents
Advertisement
Series 800 Maintenance Manual
Remove Print Mechanism from Printer Mechanism Assembly
Figure 20: Remove Print Mechanism
1.
Unplug all Print Mechanism connectors from the Controller PCB Assembly.
2.
Firmly grasp the sides of the Print Mechanism, and rotate it towards the rear of the Print Mechanism
Assembly. It will unsnap from two (2) leaf springs holding it in place.
3.
To re-install the Print mechanism, re-install all connectors to the Controller PCB Assembly.
4.
Locate the rear slot of the Print Mechanism on the centered locating tab, and rock the front of the Print
Mechanism downward, re-snapping it back into place.
Page
28
Confidential Information: Not for Distribution.
Rev C
Assembly/Disassembly
Mar-03
Advertisement
Table of Contents
