Table of Contents
Advertisement
Operational Procedures
3.
Slide the printer mechanism assembly back into the closed position, making sure that the assembly's
slide plungers snap into the racking retainers within the outer slide chassis.
4.
The printer is ready to receive information.
Removing Loaded Tickets
The Series 800 printers have two ways to remove unused tickets from the printer mechanism assembly.
The first way is to release the plastic actuator latch to release tickets from within the printer mechanism
assembly. After the actuator latch is pulled toward the front of the printer, the platen/cover assembly can be
rotated up towards the front of the printer. This will allow an opening that provides space to clean the
printhead, check the printer for ticket jams, or prepare the paper path for ticket replenishing. The second
way is to use the feed button, it will feed out tickets from within the printer mechanism assembly.
Figure 14 Actuator latch and platen/cover assembly
Unloading Tickets from the Printer by opening the Platen/Cover assembly
1.
Pull printer mechanism assembly out of the slide chassis until it stops in the open position
2.
Pull the plastic actuator latch towards the front of the printer.
3.
Swing the platen/cover assembly up and towards the front of the printer.
4.
Remove all tickets from the ticket path and check for any debris.
5.
Press the green label to relatch the platen assembly.
6.
Proceed with ticket loading procedure.
Mar-03
Confidential Information: Not for Distribution.
Series 800 Maintenance Manual
Rev C
Page
21
Advertisement
Table of Contents
