Removal Of Fan Motor - Gree U-Match 5 Series Manual

GREE
4.5.2.4 Wall Mounted Type
Note:
The following steps are specific for GUD100G/A-T units. For other units, the assembly and disassembly
procedure is similar except the numbers of louvers and motors.
Step
1. Remove the louver
2. Open the front panel
3. Remove the electrical box
cover 2
4. Remove the front panel
assembly
5. Remove the electrical box
cover 1
6. Remove the main board

Removal of Fan Motor

Remark: before removing, making sure power is disconnected.
Diagram
U-Match 5 SERIES UNIT SERVICE MANUAL
150
Operation Procedure

Take off the axle bush of the
louver.

Remove the louver.

Hold the indents on both sides of
the panel and pull it out in the
direction shown by the arrow.

Unscrew the screws fixing the
electrical box cover with a
screwdriver. Take off the box
cover 2.

Detach the ambient temperature
sensor from the conduit.

Unscrew the screws fixing the
front panel assembly.

Remove the front panel
assembly.

Press on the buckle of the box
cover 1 and then take off the
cover.

Release the wiring terminals
connected to the main board.

Remove the main board.