Removal Of Air Guide Louver; Removal Of Display Panel And Fan Assembly - Gree U-Match 5 Series Manual

GREE
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components, especially
the connectors of air guide louver.
Step
Remove the air guide
louver assembly.
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components.
Step
Remove the water tray.
Note: Make sure power is cut off. Take good care of the copper pipe and aluminum fins. If the removal takes a long time, seal the
copper pipe.
Step
Remove the evaporator
assembly.
Note: Before removal, make sure power is cut off. During the removal procedure, take good care of all the components.
Step
Remove the display panel
and fan assembly.

Removal of air guide louver

Picture
Removal of water tray
Picture
Removal of evaporator
Picture

Removal of display panel and fan assembly

Picture
148
U-Match 5 SERIES UNIT SERVICE MANUAL

Remove the air guide louver
from its supporting
assembly. Then take off the
connectors from the swing
motor. (As shown in the
picture, the lines indicate the
supporting assembly.)

Remove the water tray.

Twist off the 6 screws of the
evaporator, 3 screws of the
plate board of water
releasing flume, and 2
screws of the water tray.
Then remove the evaporator.

First remove the display
panel, next the bracket and
then the swing motor
mounting plate.
Work instruction
Work instruction
Work instruction
Work instruction