Gree U-Match 5 Series Manual page 116

GREE
Model: GUD35W/NhA-T, GUD50W/NhA-T, GUD71W/NhA-T, GUD85W/NhA-T
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step
1. Remove the panels.
2. Remove the electric box.
3. Remove motor support.
4. Remove the condenser.
U-Match 5 SERIES UNIT SERVICE MANUAL
Removal of condenser
Picture
113
Work instruction

Remove the upper, lower and
front panels.

Loosen the wire clamp at the
bottom of the electric box.

Unscrew the screws of electric
box.

The connection wires inside
and outside the electric box
should be removed.

When removing the motor
support, be careful to protect
the components.

Heat up the welding points of
connection pipes through gas
welding until the pipes break
off. Note: When welding the
pipes, do not let the flame
burn the other components.
The welding points of
condenser are steel and
copper welding points. Be
sure to maintain the welding
quality.