Removal Of Condenser - Gree U-Match 5 Series Manual

GREE
Step
5. Install the fan.
6. Install the grill.
Model: GUD100W/NhA-T, GUD125W/NhA-T, GUD140W/NhA-T, GUD100W/NhA-X, GUD125W/NhA-X,
GUD140W/NhA-X
Note: Before removing the condenser, make sure there is no refrigerant in the pipeline and power is cut off.
Step
1. Remove the panels.
2. Remove the electric box.
Removal of fan and motor
Note: Before removing the fan, make sure power is cut off.

Removal of condenser

Picture
U-Match 5 SERIES UNIT SERVICE MANUAL
Picture
124
Work instruction

Install the fan in place. Put
on the gasket and use a
wrench to secure the
screw nut.
Note: After installing the
fan, turn the fan by hand to
see if it can run normally. If
not, please check for the
reason.

After replacing the motor,
use a screwdriver to
tighten up the screw bolt
that secures the motor.
Arrange the wires
according to the wiring
diagram.
Work instruction

Remove the upper, lower and
front panels.

Loosen the wire clamp at the
bottom of the electric box.

Unscrew the screws of electric
box.

The connection wires inside and
outside the electric box should be
removed.