Table of Contents
Advertisement
7. Installation Manual
7.1 Seleection of Installation Location
● Such a place where cool air can be distributed throughout the room.
● Such a place where condensation water is easily drained out.
● Such a place that can handle the weight of indoor unit.
● Such a place which has easy access for maintenance.
● The appliance shall not be installed in the laundry.
7.2 There are 2 Styles of Installation
● CEILING TYPE
● FLOOR TYPE
Each type is similar to the other as follows;
Indoor unit
The indoor unit should be sited in a place where:
1) the restrictions on installation specified in the indoor
unit installation drawings are met.
2) both air intake and exhaust have clear paths met.
3) the unit is not in the path of direct sunlight.
4) the unit is away from the source of heat or steam.
5) there is no source of machine oil vapour (this may shorten indoor unit life).
6) cool(warm) air is circulated throughout the room.
7) the unit is away from electronic ignition type fluorwscent lamps
(inverter or rapid stert type) as they may shorten the remote controller range.
8) the unit is at least 1 metre away from any television or radio
set(unit may cause interference with the picture or sound).
7.3 Cautions for Installation where air
Conditoner Troubleis Liable Tooccur
● Where there is irregular electrical supply.
● Where it is acid base area.
● Where there is too much of oil area.
Indoor Unit Installation Drawings
The indoor unit may be mounted in any of the three styles shown here.
Exposed
Mounting plate
Molding
Floor lnstallation
Wall Installation
16
Half conceated
Concealed
Grid(field supply)
Location for securing the installation panel.
Schematic drawing of hooks:
Front grille
Front panel
150cm or more
150cm
or more
150cm
or more
Installation Manual
Unit:mm
150cm or more
150cm or more
INSTALLATION
PAPER PLANK
150cm
or more
150cm
or more
15cm or below
from the floor
Advertisement
Table of Contents
