Basic Operation; Operation Mode - Canon Color imageCLASS MF9170c Service Manual

5.2 Basic Operation

5.2.1 Operation Mode

imageCLASS MF9170c / imageCLASS MF9150c / imageCLASS MF8450c
Single-sided continuous pickup
The following shows the operation sequence when two sheets of single-sided documents are set on the document tray.
1) The ADF paper sensor (SR718) detects the document loaded on the document tray, and sends a signal indicating "paper exists" to the main controller.
2) The ADF pickup motor (M13) rotates forward.
Driven by the ADF pickup motor, the ADF pickup roller moves down until it reaches the document, and then feeds the document.
In this condition, one sheet of the upper-side document is picked up by the ADF separation roller and ADF separation pad.
ADF separation roller
3) When the lead edge of the document reaches the ADF feed roller, the feed speed becomes approximately 1.2 times (which is the same as the reading speed).
If no 'stop' request is sent from the main controller when the lead edge of the document reaches in front of the reading position, reading operation starts.
4) When reading is completed, the document is delivered to the ADF delivery tray by the ADF delivery roller.
When a specified period of time elapses after the trailing edge of the first page passes through the ADF separation roller, the second page is picked up by the
ADF pickup roller.
Because the ADF feed roller rotates faster than the ADF separation roller, a specified interval is secured between the first and second pages.
ADF separation roller
M13 SL5016
SR718
ADF separation pad
M13
Reading position
ADF pickup roller
M13
ADF feed roller ADF delivery roller
ADF pickup roller
F-5-4
ADF feed roller
F-5-5
ADF delivery tray
F-5-6
Chapter 5
0019-8972
5-3