(2) Numeric parameter
Parameter No.
01
02
03
04
05
06
07
08
16.5 TESTMODE
16.5.1 SYSTEM
16.5.1.1 SYSTEM List
imageCLASS MF9170c / imageCLASS MF9150c / imageCLASS MF8450c
<DRAM>
Check DRAM
Sub item
TEST1
Check writing/reading of data in DRAM area (excluding system work area)
TEST2
Check data reading (high speed)
<ACC>
Check ID control card reader
Sub item
NCR-CRD
Display: presence/absence of NCR device or the card
CRD-KIND
Card type (the first 3-digit characters)
CRD-STYL
Card format (the second 3-digit characters)
READ-STS
Read status (the third 3/2-digit characters)
NCR-STS
Device status (the fourth character)
NCR-VER
Version of NCR device (4-digit numeric figures)
<SPEAKER>
Check SPEAKER
Sub item
ON
When "ON" is selected, increase the volume step by step from the minimum up to maximum whenever OK key is pressed. When reaching the
maximum volume, it goes back to the minimum volume through silent state.
MIN
When "MIN" is selected, set off the minimum volume with OK key.
MAX
When "MAX" is selected, set off the maximum volume with OK key.
VOL
Set off the volume according to the hardware volume.
16.5.2 SCAN
16.5.2.1 SCAN List
imageCLASS MF9170c / imageCLASS MF9150c / imageCLASS MF8450c
<ADJUST>
Sub item
WLVL-ADJ
Correct white level in copyboard scanning and stream scanning to determine shading target.
T-16-58
Function
T1 timer
T2 timer
T3 timer
T4 timer
Signal sensing table
Signal sensing level
Number of signal frequencies
T-16-59
TESTMODE > SYSTEM > DRAM
Description
T-16-60
TESTMODE > SYSTEM > ACC
Description
T-16-61
TESTMODE > SYSTEM > SPEAKER
Description
T-16-62
TESTMODE > SCAN > ADJUST
Description
Setting Range
0 to 9999 (x 10 ms)
0 to 9999 (x 10 ms)
0 to 9999 (x 10 ms)
0 to 9999 (x 10 ms)
0 to 16
0 to 9
0 to 9999 (pce)
Chapter 16
0020-2024
0020-2025
16-35