Removing The Low Voltage Power Supply Pcb - Canon Color imageCLASS MF9170c Service Manual

Chapter 10
1100mm
1) Remove the ETB unit.(page 7-31)Reference [Removing the ETB Unit]
2) Remove the fixing assembly.(page 9-6)Reference [Removing the Fixing
Assembly]
3) Remove the rear cover unit.(page 10-11)Reference [Removing the Rear
Cover Unit]
4) Remove the ADF Unit + Reader Unit.(page 4-8)Reference [Removing
the ADF Unit + Reader Unit]
5) Remove the left cover.(page 10-13)Reference [Removing the Left Cov-
er]
6) Remove the right cover.(page 10-11)Reference [Removing the Right
Cover]
7) Remove the Upper Frame Unit.(page 10-18)Reference [Removing the
Upper Frame Unit]
8) Remove the Reversal Unit.(page 8-28)Reference [Removing the Revers-
al Unit]

10.5.16.2 Removing the Low Voltage Power Supply PCB

imageCLASS MF9170c / imageCLASS MF9150c / imageCLASS MF8450c
1) Remove the switch button unit [1].
- 2 screws [2]
[2]
F-10-63
2) Disconnect the connector [1] and remove the 4 screws (TP) [2] and the
screw (with washer) [3].
10-24
0019-5739
[1]
[3]
F-10-64
3) Remove the wire saddle [1] and disconnect the 5 connectors [2].
[2]
F-10-65
4) Move the low voltage power supply PCB [1] in the direction of the arrow,
and free the 5 harnesses [3] from the harness guide hole [2].
[2]
[1]
[2]
[1]
[2]