Operation Panel Unit; Removing The Control Panel Unit; Procedure After Replacing The Control Panel - Canon Color imageCLASS MF9170c Service Manual

F-10-52

10.5.11 Operation Panel Unit

10.5.11.1 Removing the Control Panel Unit

imageCLASS MF9170c / imageCLASS MF9150c / imageCLASS MF8450c
1) Remove the panel stand left cover [1] and the panel stand right cover [2].
- 1 claw [3]
F-10-53
2) Remove the control panel unit [1].
- 2 connectors [2]
- 1 clamp [3]
- 2 screws [4]
[1] [4]
[4]
F-10-54
Point to Note at Installation
Be sure to fit the 2 bosses [1] of the control panel unit into the 2 grooves [2]
of the stand to install.
[1]
[1]
[2] [3]
[3]
[2]
0018-9105

10.5.11.2 Procedure after Replacing the Control Panel

imageCLASS MF9170c / imageCLASS MF9150c / imageCLASS MF8450c
After replacing the control panel, adjust the flicker value of the control panel
using the service mode.
1) Using the service mode, make the machine display the flicker value ad-
justment screen for the control panel.
TESTMODE> PANEL> FLICKER CHECK START
2) Press the [OK] key.
The flicker value entry screen is displayed.
[1]
[2]
[2]
F-10-55
F-10-56
Chapter 10
0021-0350
10-21